ATECH CRATER-06 A, Руководство пользователя

Страница: 16 / 20

16
8.1.5. Fit the other parts (Washer and Saw Flange) in order, following the reversal of the operations on the shaft.
8.1.6. Tighten the M10 screw by turning it clockwise with an 8 mm Allen key (Hold the saw blade shaft at the
opposite end with another 8 mm allen key to prevent the shaft from turning).
8.1.7. The saw blade you use must be sharpened / changed at certain intervals depending on the type of
material being cut. When the cut workpiece is burrned at the end of cutting or when the cutting is
forced, sharpening / replacement of saw blade is necessary.
8.1.8. When replacing the saw blade with a new one, use the portion of the saw blade that corresponds to
the saw blade diameter. You can order new saw blades from ATech. The bore diameter is both 30
and 32mm.
9. SAFE INSTALLATION OF MOTOR BELT
Follow the instructions below to safely replace the motor belt of your saw:
9.1.1. Move the MAIN SWITCH on the machine to position 0. Open the front door with the key.
9.1.2. Remove the M6 screw by turning with a 5 mm allen key.
9.1.3. Remove the belt cover.
9.1.4. Loosen the M10 key-head bolt with the 10 mm keys.
CAUTION!
Ø450 mm (18”) Saw
Blade
Saw Blade Coupling
Saw Blade
Washer
Saw Flange
Washer
30x8x7
M10x20
Imbus Screw