AT&T Network Adapter 25, Руководство по установке и обслуживанию

Страница: 316 / 438

APPENDIX D: System Upgrades
8.
9.
10.
11.
12.
13.
14.
Remove the ZTN82 or ZTN128 Call Processor CP from slot 2 and
discard (R1 only). Remove ZTN85 Service CP from slot 3 (R1 only) or
slot 2 (R2 only) and replace with ZTN131 Service CP. (Put in slot 2.) If
ZTN85 is not replaced, move ZTN85 to slot 2.
Power up the system-Cabinet 1 last.
Cold start the system. Refer to “Cold Start the System" in Section 2.
Restore the translations from the backup tape. Refer to “Using the DTU”
in Section 4.
Install any new port circuit packs.
Caution: Do not Install new port circuit packs until after
backup tape has been restored.
N o t e : The system must be idle to perform the following step.
From R1 to R3 one: The new slot location (slot 2) of the ZTN131 CP
must be translated as follows:
●
Select Menu
1
.
●
Remove port 10301 by entering Port=10301, Action=1, and
Data=0.
●
Assign port 10201 by entering Port=10201, Action=1,
D a t a = 1 1 0 2 .
Enter new or changed transations as needed so that the customer
can use the new R3 capablities (Note). Refer to the Administration
Manual for R3V1 (555-540-500) for these procedures.
Note: If you are replacing a direct trunk console with a switched
loop console, you must remove the direct trunk console
translations and enter translations for the switched loop
console. Also, the switched loop console does not have a
NIGHT SERVICE button by default; therefore, you must
administer one, if the Night Service feature is required (note
the Night Service Access code before switching the
consoles). Set trunk priority to ring-in on SLAC Menu 1,
Action=11, Data=1 through 7.
D-2
November 1995