14.
Apply a
very thin
coating of fresh 10W30 engine
oil onto the now clean seal faces (faces only) in a
circular motion. (fig. 11-38)
15.
Press the bearing sleeve assembly (with face seal
clean, installed, and oiled) into the hub with tool
0403-550 until seated. (fig. 11-39)
16.
Flip the hub over, support the bearing sleeve from
the bottom with tool #: 0403-551 and set it onto
the press for center seal installation. (fig. 11-40)
17.
Install the center seal into the hub. Work the lip
around the bearing sleeve with your fingers prior
to pressing it into place. (fig. 11-41)
18.
Install the front race into the hub as shown above
the seal. When the race is pressed into place, it
will push the seal into position. (fig. 11-42)
19.
Install the bearing (cleaned, dried and repacked
with ASV Multi-Purpose EP Lithium Grease) onto
the bearing sleeve as shown. Press into the
assembly until seated against the race. (fig. 11-43)
11-10
Rubber Track Loader
11. Undercarriage Disassembly and Assembly
11-38
11-39
11-40
11-41
11-42
Part #: 0403-551
11-43
Part #: 0403-549
Part #: 0403-545
Part #: 0403-550
