Statement
This device is intended only for OEM integrators under the following
conditions:
1. The antenna must be installed such that 20 cm is maintained between the
antenna and users.
2. The transmitter module may not be co-located with any other transmitter
or antenna.
3. For laptop installations, the antenna must be installed to ensure that the
proper spacing is maintained in the event the device is used in held-on-
lap positions (i.e. positioning of antennas must be placed in the upper
portion of the LCD panel only to ensure 20 cm will be maintained if the
user places the device on their lap for use).
The card must cease to transmit with the lid shut to prevent transmission
in portable operating conditions.
As long as the conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be met
(for example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the
antenna may be installed such that 20 cm may be maintained between the
antenna and users (for example access points, routers, wireless ADSL
modems, and similar equipment). The final end product must be labeled in
a visible area with the following: "Contains TX FCC ID:
MSQPCCWL120".
ASUS WLAN MiniPCI Card
6
