Asus iPBX30, Руководство пользователя

Страница: 44 / 160

iPBX30 User Manual Chapter 5
31
5.2.2.1 WAN PPPoE Configuration Parameters
The table below describes the configuration parameters available
for the PPPoE connection mode.
Table 5.2. WAN PPPoE Configuration Parameters
Setting Description
Link Select a port to configure. Available options are WAN1, WAN2
or DMZ.
Connection
Mode
Select PPPoE from the connection mode drop-down list.
PPPoE
Session Select the PPPoE session ID for this PPPoE session. Note
that only two simultaneous PPPoE sessions are supported.
Enable Check or uncheck this box to activate or de-activate this
PPPoE session.
User
Name and
Password
Enter the username and password you use to log into your
ISP. (Note: this is different from the information you used to
log into the software application.)
Service
Name Enter the service name provided by your ISP. Service name is
optional but may be required by some ISPs.
AC Name Enter the access concentrator name provided by your ISP.
Access concentrator name is optional but may be required by
some ISPs.
IP Address If your ISP allows you to always obtain the same IP address
for your WAN, enter it here.
Primary /
Secondary
DNS Server IP address of the primary and/or secondary DNS are optional
as PPPoE will automatically detect the DNS IP addresses
configured at your ISP. However, if there are other DNS
servers you would rather use, enter the IP addresses here.
MTU You may specify the maximum size of the transmitted packet.
For PPPoE, the range of MTU is from 546 to 1492. The
default value is 1454.
Disconnect
after idle
(min.) Enter the inactivity timeout period at which you want to
disconnect the Internet connection when there is no traffic. A
value of 0 means no activity time out. Note that SNTP service
may interfere with this function if there are activities from the
service.