15
P11: VALET SWITCH
Connector allowing a push-button switch to be plugged into the module to control the “Valet” mode for both the
AstroStart alarm and the antitheft application. It is also a part of the Paging system.
“Valet” mode: Press the push-button for more than 3 seconds with
the key ON and the engine NOT
running.
“Paging” mode: Press the push-button for more than 3 seconds in any condition other than the one for
the “valet” mode, will transmit a call (page) to all the remotes learned in it’s memory (2 way remote only).
This switch should be mounted in a location accessible to the operator, out of plain view.
Use a 7mm (9/32") drill bit.
P12: MANUAL INTERFACE
Five-pin connector used to connect the manual interface.
The manual interface monitors the status of the doors and parking brake for initialization of the
system activation sequence.
The purpose of this sequence is to increase safety by forcing the user to ensure that the gearshift
lever is not in gear when leaving the vehicle and planning to remote start it later.
P13: MAIN SWITCH
Three-pin connector designed for a plug-in on/off switch. This switch overrides the remote start functions, while
maintaining all other functions.
The switch should be mounted in a location easily accessible by the operator, such as under the dashboard, where
the driver can reach it easily. The round shape of the switch allows you to install it on the dashboard, using a 1/2"
drill bit.
P15: RECEIVER CONNECTOR
A four-pin connector for direct connection to the supplied receiver.
Mount the receiver module below the tinted strip on the windshield, or if windshield has no tinted strip, about 10 cm
(3-1/2") from the roofline, with the connector facing up.
NOTE
: If the windshield is of the heated variety, an alternative location must be selected, as a windshield of
this type will impede reception of the remote control signal.
P16: IM – OM – IOM ACCESSORIES CONNECTOR
This is an eight-pin connector designed to plug directly into an AstroStart alarm/anti-theft interfacing module.
All dedicated devices interfacing
the remote start module to an
OEM or immobilization alarm will
be equipped with a connector
allowing connection to this P16
location.
Note: The Green (P2-6), Orange (P2-7), White/Blue (P2-14) and the Brown (P2-13) are linked to the P16
connector by the internal board. If these wires are used on both connectors, isolate them with diodes.
D
ESCRIPTION OF
H
ARNESS
B
ROWN
:
O
UTPUT
(-)
L
OCKING
B
LUE
:
O
UTPUT
(-)
U
NLOCKING
B
ROWN
/W
HITE
:
P
ROGRAMMABLE
O
UTPUT
1
(-)
W
HITE
/B
LUE
:
P
ROGRAMMABLE
O
UTPUT
2
(-)
O
RANGE
:
O
UTPUT
A
NTI
-
THEFT
(-)
G
REEN
:
O
UTPUT
(-)
WHEN RUNNING
B
LACK
:
G
ROUND
RED:
+12VDC
Содержание BBF
Страница 30: ...28...
