Page 11
Programming with the HE programming software
Operating Instructions V 112 -
Version 07-2009A
Specifying the output parameters
The user is able to select the output parameters for the two output
channels of the V 112. In the
Overview
, specify the parameters for
output channel A in the
RF parameters A
input field and for out-
put channel B in the
RF parameters B
input field (see left).
A
UFGABE
1.
In the
Overview
, click on the
Details
button (see left) to
open the window for the
Parameters of the plug-in
card
. You can make all the settings required for operation in
this window.
2.
In the
Output parameters
area you can enable or disable
the selected channel by placing or removing a check mark in
the relevant checkbox.
3.
If you have installed the optional output channel filter in the
V 112, you must select "Yes" from the "RF channel filter"
drop-down list.
4.
Use the audio mode drop-down list to set the audio mode (see
left). You have the following options available: "Mono",
"Stereo", "Dual L (R)" and "Dual R (L)".
5.
You can apply the configuration changes to the plug-in card by
clicking on the
Program card
button in the top right of the
Parameters of the plug-in card
window (see left).
The output frequency display depends on the choice of output
channel in the
Overview
of the base unit. If the "free" option is cho-
sen instead of selecting an output channel in the Overview, then the
Frequency field in the window for the
Parameters of the
plug-in card
is enabled and the user can enter any output fre-
quency.
E
RGEBNIS
:
You have now set the output parameters.
