ASTRO LS10 Series, Руководство пользователя

Страница: 28 / 50

Problem Solutions
Applicator and hose fail to heat
1. Check incoming hose power connector to see if
properly installed. Connector wire pins may be
misaligned or loose.
2. If no change, disconnect incoming hose power
connector and check hose heater resistance with
ohmmeter. If hose heater fails, replace hose. See
Slautterback Heated Hose Manual.
3. Determine if applicator is heating by using a
pyrometer or temperature sensing device. Do not
touch applicator by hand to determine temperature.
Refer to the handgun manual.
Adhesive output too high
1. Decrease system fluid pressure with flow control
valve. If no change, remove nozzle and replace with
a smaller orifice nozzle.
2. Decrease hose temperature by 4–10 °C (25–50 °F).
If no change, consult your hot melt material vendor
regarding application.
Adhesive output too low
1. Increase system fluid pressure without stalling the
motor by adjusting flow control valve. If no change,
remove nozzle and replace with a larger orifice
nozzle
2. Clean applicator nozzle.
3. Purge system.
4. Increase hose temperature by 4–10 °C (25–50 °F). If
no change, consult your hot melt material vendor
regarding application.
5. Hot melt formulations tend to be a factor in
previously listed problems. Refer to Start-up for
cautions.
•
If troubleshooting attempts fail, please contact your distributor.
22 LS10 and LS20 19600-121

Copyright 2010 Astro Packaging