Page 19
Configuration via the web interface
Operating Manual HDIQ 4 -
Version 02-2022A
In the following lines you can make the settings for the individual transport streams (SPTS and MPTS).
Below this you see the entries for service IP address, subnet mask and gateway.
Modulator
To edit the modulation parameters for the DVB-C output, click “Modulator” in the main menu on the left.
You then see the table “Modulator Configuration” (see Fig. 9).
Fig. 9: Configuring the modulator
In the first line you can activate or deactivate the QAM signal for outputs A, B, C and D. The following
parameters can be edited.
You can edit the following parameters here:
Standard: J.83A (DVB-C), J.83B or J.83C (For Europe, the standard is J.83A (DVB-C)).
Constellation: J.83A: 16QAM 32QAM, 64 QAM, 128QAM, 256QAM;
J.83B or J.83C: 64QAM or 256 QAM (for Europe, 64QAM or 256QAM applies.)
Symbol Rate: 5,000 to 9,000 MS/s. Recommendation: 6,900 MS/s
RF Frequency A: Adjustable from 30 to 960 MHz in 1 kHz increments
RF Frequency B: Adjustable from 30 to 960 MHz in 1 kHz increments
RF Frequency C: Adjustable from 30 to 960 MHz in 1 kHz increments
RF Frequency D: Adjustable from 30 to 960 MHz in 1 kHz increments
RF Outlevel: Adjustable from -30 to -10 dBm in 0.1 dBm increments
Output E Bitrate: Data rate of Output E (MPTS). 0 to 99,000 Mbps. Recommendation: 50,000
ASI Output: One of the outputs A, B, C, D can be mirrored to the ASI output.
Select the required output here.
DRAFT VERSION
Содержание 4026187240868
Страница 1: ...Version 02 2022A DRAFT VERSION ...
