Aston Global SD908, Инструкция по установке и эксплуатации

Страница: 15 / 23

4. Remove the decorative nut, locking nut, and plastic washer. Leave the plastic
tube and back plastic washer on the door roller.
5. Taking the door, and slide the door over the top two-door roller mounts.
IMPORTANT: The plastic tubes must be inserted into the two top mounting holes
in the door.
6. Reinstall the plastic washers onto the top roller and then install the metal
locking nuts. Hand tighten the locking nuts.
7. Repeat the process on the two lower roller mounts ensuring that the plastic
tubes are inserted in the glass door and then reinstall the plastic washer and metal
locking nut and hand tighten.
8. Check the door seal down the length of the seal. If it is not in full contact, use
a flat head screw driver and adjust the top roller mounts so that the door seal is in
contact for the entire length of the door.
NOTE: A cam roller inside of the door roller is used for adjustments of the door. By
turning this cam, you will raise or lower the door by adjusting the seal.
9. After making the final adjustments, tighten all of the metal locking nuts.
10. Install the decorative nut covers.
11. Install the vinyl door “F” type seals on each door so that the squeegee flaps
will wipe the glass when opening and closing.
14