Aston Global Moselle SDR976, Инструкция по установке и эксплуатации

Страница: 11 / 27

1. Slide the door stoppers (1) onto each end of the the top rail (2). The
bumpers on door stoppers (1) should face inward and be on top for final
installation. See figure 1.
2. Assemble top rail (2) to fixed glass (3) following the assembly sequence
shown in figure 2. Note the door stopper (1) is positioned between the Fixed
Glass assembly hardware. See figure 2. Note: The top rail (2) is attached to
the inside of the fixed glass (3). Install both rail ends onto the rail.
3. Loosen set screw on rail ends (5) and remove wall mounts (6) from rail ends
(5). Next slide rail ends (5) onto each end of top rail (2). See figure 3.
4. Place the fixed glass top rail assembly into your desired location.
Note: The top rail (2) attached to fixed glass (3) should face inside
the shower.
Using a level, verify the top rail (2) is horizontal and the fixed glass (3) is
plumb. Using a pencil, mark the rail ends onto the wall.
5. Remove pre-installed screw from pre-assembled glass clamp (7) Position the
side of the glass clamp (7) with shower tray mounting hole on the shower tray
and align with large hole opening on bottom of fixed glass (3). Mark the
mounting hole of glass clamp (7) at this position. See figures 5.
NOTE: If your surface is prone to cracking or chipping then it is
recommended that you pilot drill first using a smaller drill bit, and then step
up to the final size.
6. Using the appropriate drill bit for your shower tray surface drill hole locations
with 1/8" diameter drill bit.
10