.
.
DESCRIPTION
Please keep internal/external panel clean before installation.
2
3
Change Handle Direction
Lock Body Change Direction
Lock Body and Gusset plate Installation
Handle Alignment
Outside Panel Accessory
The triangle arrow of clutch
wheel should face downwards
Reversing stop piece
Oblique Latch
Screw
Gusset
Plate Box Lock Body
Square Latch
Handle change
direction screw
Install the door buckle plate on the door frame
directly opposite the lock body. The hole of the
buckle plate shall correspond to the tongue of
to the lock body. If there is any deviation, it must
be adjusted to the appropriate position.
Use 2 screws to tighten lock body on frame and
make sure lock body and door panel are parallel
Fingerprint wire should
always follow handle direction
Inside Panel Accessory
When installing lock body - Oblique latch
should always be on top while square latch
should at bottom. Oblique should face door
closing way otherwise it has to be adjusted.
Post this follow below steps:
1) Turn reverse stop unit upwards
2) Push in oblique latch and turn 180
degrees
3) Take out oblique latch
Battery Cover
Screw Hole
Battery cover
Reset Button
Inside Handle
Front Handle
Lock Switch
Screw Hole
Body Cover
Keypad
RFID Scanner
Emergency Power Slot
Manual Key
