7
Signature
®
Series
Signature protected key blanks in your assigned code key pattern are available only from the SARGENT factory
or through an authorized SARGENT distributor.
(See section “How to Order Signature Components” for further details).
No special equipment is required for cutting new or copying existing key bittings onto the dimpled Signature key
blanks. This process can be accomplished using any industry standard key cutting or duplicating equipment.
Lubrication
Since the Signature side pins and side pin springs are assembled, lubricated and sealed at the factory, it is not
necessary to service these components.
When lubrication is required, SARGENT recommends the use of SARGENT ASSA lube (P/N 18-0070) or spray
lubricant such as “Poxylube” dryfilm lubricant CP-200.
Frequency of lubrication is dependent upon use when used on exterior doors.
Lubrication twice a year on normal use and more often for high use or exterior doors.
Note:
It is important that you don’t use liquid lubricants such as WD40. The use of solvent based liquid
lubricants will create a gummy sludge within the cylinder and can affect the operation of the cylinder and its
components.
Cutting Signature Keys
9
A7438F • 1-800-727-5477 • www.sargentlock.com
9/01/16
Copyright
©
2007, 2011, 2014, 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibite
d.
