02/11/11
A7763B 15
Copyright © 2011, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Profile Series v.S1 PoE Cylindrical Lock
Fig...8A
Step #8 – Install Gasket and Outside Escutcheon
For exterior applications, use weatherseal gasket between escutcheon and outside door
surface.
To apply weatherseal gasket:
1. Carefully remove the backing from the gasket (Fig. 8A).
2A. For fire rated doors:
Feed ribbon cable with connector and ground wire from
outside of door through weather seal gasket and fire stop plate (Fig. 8A).
2B. For non-fire rated doors
:.
Feed ribbon cable with connector
and ground wire from outside of door through weather seal gasket (if used) and
weather conduit (if used; not shown).
Note: Install ribbon cable with cable exiting down.
3. Apply gasket to escutcheon:
a. Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
b. Work around the escutcheon, pressing the
sticky side of the gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so that all edges
of the escutcheon are covered.
4. Place the outside escutcheon against, while
directing mounting posts through the door.
Cylinder spacer
Outside.of.Door
Gasket
Keypad
Ribbon
Cable
Ground
Wire
(E1)
Antenna
(iCLASS)
Only
