KP8877/KP8878 x ET x Lever Design
Keypad Operated RIM Exit Device
3
•
Plug keypad connector into inside
escutcheon as shown.The back
plate can be removed to feed the
large connector through slot into
the circuit board to be assured of
proper fit.
If connector is not fully
and properly seated on pins,
unit will not function properly.
•
Plug smaller connector as shown
into inside escutcheon
NOTE: Both connectorsin-
stall only one way. Donot
offset the connectors.Be
sure connectors areseated
completely.
Small
connector
from ET
Control
Inside
of door
Back-
plate
Keypad
connector
Inside
Escutcheon
#8-32 x 1-1/2’’ Flat
head machine
screw
52-0086
Bracket
#8 x 1’’ Screw
Inside
of door
Keypad
Outside
of door
• Securely fasten top of
inside escutcheon to top
of keypad using a #8-32 x
1-1/2” machine screw
• Securely fasten bottom of
escutcheon (52-0086) to
door using #8 x 1” screw
Outside
of door
Rim Installation Instructions for
KP8800 Series (Continued)
Step #5 Inside Controller Assembly
11
A7137C
Copyright © 2018, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
01/31/18
