31
Operate the Zone on the Home page displaying an explanation mark.
The window that does not move corresponds to the Actuator that has not
been recognized. Check for loose wiring to that Actuator.
If no loose wires are found then the Actuator could be at fault.
To remove this Actuator from the Zone so the warning is no longer displayed,
carry out the following steps:
Note: If a Rain Sensor is assigned to this Zone it will need to be removed before the
Actuator can be removed.
1. Press Setup,
Zone Setup
.
2. Press
Remove From Zone
.
3. Press the right hand side
arrow
keys to scroll to the Zone that is displaying an
explanation mark on the Home page.
4. If necessary, press the left hand side
arrow
keys and scroll to the Actuator
that is
coloured red
.
5. Press
Remove From Zone
.
6. Press
Setup
to go back to the Zone Setup page then press
Setup
again to go
back to the Setup page.
7. Press
Yes
to save your settings.
The warning should now be resolved in the Home page.
If not, contact your installer.
18
NOTES
