6
ED8400 Series
Installation Instructions
Vertical Rod Exit Devices
FM22 06/19
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
3
Installation
a
Install Trim
CAUTION
Refer to the template packed with trim before proceeding with step 3.
Figure 5
Knob Trim
Pull Trim
Follow illustration below for
trim installation procedure.
Must be
vertical
Must be
vertical
Keyway
Not this
This
ANSI/BHMA cylinder
plate (optional)
Mount keyway in knob vertically as shown.
Inside of door
Inside of door
Latch edge of door
Latch edge of door
Outside of door
Outside of door
Keyway
Right Hand
Reverse
Bevel Door
Left Hand
Reverse
Bevel Door
Blank plate used
when cylinder is omitted.
Cut off length of cylinder connecting bar so that 3/16"
projects beyond inside face of door.
ANSI/BHMA
cylinder plate
Cut cylinder attaching screws
off to suit door thickness.
Mount cylinder horizontally as shown. Cut off length of cylinder
connecting bar so that 3/16" projects beyond inside face of door.
View reversed to show
proper mating position
when installed.
Boss
Boss
Caution
When using the ANSI/BHMA cylinder plate, be sure the bosses on the latch assembly fit into the cutouts
on the cylinder plate so that the latch assembly lies flat on the door.
b
Locate Latches
Locate top and bottom latch. Mark for later installation. (Figure 3)
