9
ED8400 Series
Installation Instructions
Vertical Rod Exit Devices
FM22 06/19
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
3
Installation (cont .)
f
Mount Bottom Latch
Insert bottom latch screw through slot in latch frame
into bottom hole. Do not tighten. Lift up slide
assembly and fit the spring loop over the stump on
the latch frame. Position latch frame so that latch
engages strike. Now tighten bottom screw. Drill a
hole for the cover screw, using the hole in the slide
assembly at top as guide. Spot with 1/4" drill. Drill
through with #3 drill for self-tapping screw.
g
Mount Top Latch
Retract the latch by pushing up on slide and fasten latch assembly with screws as illustrated. Be sure to
draw the screw up tight. Drill hole for the cover screw, using the hole in the slide assembly at bottom as
guide.
Figure 12
Latch Screw
Door
Screw
Figure 11
Bolt Engages Strike
Tighten Screw
Spring Over Stump
Do Not Tighten Screw
Spring & Loop
Bottom Latch
Stump