Assa Abloy Alarm Controls KP-300, Руководство по эксплуатации

Страница: 7 / 12

7
KEYPAD SILENT MODE
The keypad beeper can be silenced.
1. Put the keypad in
Program Mode by entering the Installer Code followed by
the “

”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “ 8 3 0 # ”.
3. Enter “

” to exit Program Mode. The yellow LED will begin blinking.
To return the keypad to audible mode -
1. Put the keypad in
Program Mode by entering the Installer Code followed by
the “

”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “ 8 3 1 # ”.
3. Enter “

” to exit Program Mode. The yellow LED will begin blinking.
When the keypad is programmed for Auto Entry Mode it is not necessary to
terminate User Codes with the “ # ” during operation. However, in Auto Entry
Mode the User Code must be the same length (4 to 8 digits) as the Installer
Code .
To put the keypad in Auto Entry Mode -
1. Put the keypad in Program Mode by entering the Installer Code followed by
the “

”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “ 8 2 1 # ”.
3. Enter “

” to exit Program Mode. The yellow LED will begin blinking.
To return the keypad to Manual Entry Mode -
1. Put the keypad in Program Mode by entering the Installer Code followed by
the “

”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “ 8 2 0 # ”.
3. Enter “

” to exit Program Mode . The yellow LED will begin blinking.
AUTO OR MANUAL CODE ENTRY MODE
The Duress Output is not a programmable feature. The keypad automatically
creates a Duress Code based on User Codes . The Duress Code is the User
Code with the first digit increase by 2. For example: If a User Code is “1234” then
the Duress Code is “3234”. There are no Duress Codes created for Output 2
User Codes .
When a Duress Code is entered, Output 1 will activate and the Duress Output
will go to ground (-) and will not return to it’s normal state until a valid User Code
is entered.
The keypad does not allow
User Codes to be duplicates of Duress Codes . For
example: If the User Code is “1234” then the Duress Code is “3234” and the
keypad will not allow a User Code of “3234”.
DURESS OUTPUT