4
3
Setting up the Network Camera
3.1
Read Before Use
The use of surveillance devices may be prohibited by law in your country. The Network Camera is not only a
high-performance web-ready camera but can also be part of a flexible surveillance system. It is the user’s
responsibility to ensure that the operation of such devices is legal before installing this unit for its intended use.
It is important to first verify that all contents received are complete. Take note of the warnings in the Quick
Installation Guide before the Network Camera is installed; then carefully read and follow the instructions in the
Installation chapter to avoid damage due to faulty assembly and installation. This also ensures the product is used
properly as intended. It is designed for various applications including video sharing, general security/surveillance,
etc.
3.2
Hardware Installation Steps
After unpacking the package and identifying its parts, assemble the network camera to run the device for the first
time.
It is recommended set up the camera before installing it to the intended location.
The following instructions will consist of basic steps that will help you through the hardware preparation.
Other required devices before powering up the Network Camera:
1.
Personal Computer or Laptop; and
2.
Network Hub or Switch and 2 (two) pieces of Ethernet Cable; or
3.
1(one) piece of Crossover Ethernet Cable
STEPS:
1.
Use an Ethernet cable to establish connection between the camera’s network port and a network
hub/switch. Then, connect the power adapter (For Network Cameras that are
Power-over-Ethernet supported, the Power Adapter is not necessary). Refer to the images below.
2.
After the Power Connector is plugged in, the Network Camera will boot up.
3.
Wait a few seconds for the Network Camera to startup
4.
Refer to the section of “Using the Network Camera for the first time” in the next page
Another end of the cable
to a network hub/switch
Another end of the power
adapter to a power outlet
