ASM 249616, Операция

Страница: 10 / 16

Operation
10 311206A
Note: Inspect fittings for leaks. Do not stop leaks with
your hand or a rag! If leaks occur, turn sprayer OFF
immediately. Follow Pressure Relief Procedure, page
6. Tighten leaky fittings. Repeat Startup , steps 1-8 . If no
leaks, continue to trigger gun until system is thoroughly
flushed. Proceed to step 9.
10. Place siphon tube in paint pail.
11. Trigger gun again into flushing fluid pail until paint
appears.
Switch Tip and Guard Assembly
1. Engage trigger safety.
2. Insert SwitchTip
TM
. Insert seat and OneSeal
TM
.
3. Screw assembly onto gun. Hand tighten.
Spray Test Pattern
1. Trigger gun and spray test pattern. Slowly adjust
pressure to eliminate heavy edges. use smaller tip
size if pressure adjustment can not eliminate heavy
edges.
2. Hold gun perpendicular, 10-12 in. (25-30 cm) from
surface. spray back and forth. Use strokes over-
lapped by 50%. Start gun movement before trigger-
ing gun and release trigger before stopping gun
movement.
3$,17
WLD
WLE
WLE
WLE
6ZLWFK7LS
VHDW
2
1(
6
($/
WLD
KHDY\
HGJHV
WLD
WLD