ASL INTERCOM F200, Быстрый старт

Страница: 54 / 73

Communications Interface
8.7 Trigger Command Group
The TRIGger commands are used to control the instruments operation.
8.7.1 INITiate
Command INIT
INITIATE
Return None
Function Abort the current measurement cycle.
Clear the last measurement from the display.
Clear the output buffer.
Set the trigger mode to Single shot.
Initiate a single measurement of the current selected input channel without
returning a reading, up date the instrument display with the new reading.
Return the instrument to Hold.
Use the FETCh? command to transfer the reading to the output buffer.
8.7.2 ABORt
Command ABOR
ABORT
Return None
Function Abort the current measurement cycle.
Clear the last measurement from the display.
Clear the input and output buffers.
Set the trigger mode to single shot.
Set the instrument to Hold.
8.7.3 TRIGger:MODE <mode>
Command TRIG:MODE <mode>
TRIGGER:MODE <mode>
Parameters <mode> SINGle Single shot trigger mode
INFinite Infinite trigger mode (Run/Hold)
Return None
Function Set the trigger mode to single shot measurement or infinite measurement.
Setting trigger mode to single shot results in a single measurement when
initiated.
In infinite mode continuous measurement are taken when the Measure? or
Read? commands are sent.
Abort the current measurement cycle.
Clear the last measurement from the display and output buffer.
Set the trigger mode to the state as defined by the command
Set the instrument to Hold.
F200-14-001 Page 8-11
ASL 2003