EN 20
Symptom
Possible cause
Solution
Continuous beep and Er03
flashing on the display.
The control panel is dirty or
has water lying on it.
Clean the control panel.
Error code E5 and E6.
Defective generator.
Contact the service
department.
Error code E2.
Appliance over heated.
The appliance has been
switched off because of over
heating. Let the appliance
cool down and start again
on a lower setting.
Error code E3 flashing on the
display.
Unsuitable cookware
that lacks ferromagnetic
properties.
Use suitable pot or pan.
Error code U400 and/or
continuous beep.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Let your connection be
changed.
‘Flash’ symbol.
You have pressed two or more
keys at the same time.
Do not operate more than one
key at the same time.
Error code Er47.
Communication error between
controls and induction
generator.
Verify connection of main
power is correctly and
functional. Other wise contact
the service department.
Other error codes.
Defective generator.
Contact the service
department.
In case of an operation failure or if the faults / error indication does not disappear,
disconnect the cooking hob from the power mains for a few minutes (undo the fuse or
turn of the main switch); then, reconnect it to the power mains and turn on the main
switch key. If the problems persist, call a service technician.
TROUBLESHOOTING