9
2. If a Single File was programmed on the
preset button, the words "Single File
Preset" and the File Name will be
displayed, as shown in the example
below.
Preset Type
SINGlE FIlE PRESET
PROTAPER Sx & S1
File Name
3. If a User Defined Preset was programmed
on the preset button, the words "User
Defined Preset" and the Handpiece Ratio,
Speed in RPM, and Torque in
Gram•Centimeters, will be displayed, as
shown in the example below.
Preset Type
USER dEFINEd PRESET
1/8 AG 300 240
Ratio Speed Torque
4. For all programming modes:
When in the Endo DTC
®
is in operation
(with the foot pedal pressed), the
Operation Screen will be displayed. The
Operation Screen will show the
Handpiece Ratio, Speed (in RPM), Torque
(in Gram•Centimeters), Reverse Beeper
(if enabled), and Auto Stop Reverse (if
enabled).
Ratio Speed Torque
1/8 AG 300 240
BPR ASR RPM g-cm
{Reverse Beeper} {Auto Stop Reverse}
By default, the Preset Buttons are programmed
to recall the file series shown in Chart 1 on
page 5.
The Preset Buttons are also used to navigate
the various menus in the System Setup and
File Library.
The Preset Buttons can be customized to suit
individual preferences. There are three ways to
program a preset button.
The Preset Buttons can be programmed with:
1. An Entire File Series from the File Library
2. A Single File from the File Library
3. A User Defined Preset
When recalling a preset button, three different
displays will appear depending on how the
preset button was programmed:
1. If an Entire File Series was programmed
on the preset button (as is the case for
the factory default setup), the File Series
and File Name will be displayed, as
shown in the example below.
File Series
GT ACC & 20s yEllOW
GT ACC 90, 70, 50, 35/12
File Name #1
Pressing the same preset button again will
step to the next file in the file series, as
shown below.
File Series
GT ACC & 20s yEllOW
GT yEl 20/10 & 20/08
File Name #2
8. INTROdUCTION TO PROGRAMMING PRESET BUTTONS:
