Aseko ASIN AQUA NET CLF, Руководство пользователя

Страница: 22 / 36

EN 22
In Operation Measurement and
Calibration
pH Probe Calibration
When pH is being measured in operation, there may be a diff erence between
the ASIN AQUA Net value and the current pH value measured directly in water.
Calibration can be done in two ways:
1. With a buffer
• Close the water supply to the probes.
•
Remove the probe from ASIN AQUA Net rinse the probe with clean water
and wipe it.
• The probe must remain connected to the device via the cable. Immerse the
probe in the 7.0 calibration buff er and after stabilization, enter this value into
ASIN AQUA Net on the pH Probe Calibration screen.
2. With a colorimeter or Pool Tester
•
The water supply to the probes must be open
• Measure the pH value directly in pool water using a colorimeter or Pool
Tester.
•
Then enter this value into ASIN AQUA Net on the pH Probe Calibration
screen. Calibration can be performed in the range of 6.4-7.8
Do not calibrate the pH
probe with a pH difference
of less than 1.
The pH probe can be
calibrated in the pH range
6.2 to 7.8.
The pH probe cannot be
calibrated when the LOW or
HIGH warning is displayed.
If you use time dosing without
probe
Your ASIN AQUA Net is already installed, connected to pool water and to chemi-
cal agents.
•
Set up the sanitation dosing volume on 5 ml/m3 per hour if you use the
chlorine sanitation agent.
• Set up the sanitation dosing volume on 10 ml/m3 per day if you use the
active oxygen sanitation agent.
•
Set up the pH value to 6,8
Fine tune
•
Manually check the chlorine or active oxygen level in the pool water.
• Then increase or decrease the setup “dosing volume”.