Aseko ASIN AQUA NET CLF, Руководство пользователя

Страница: 10 / 36

EN 10
Pool Water Connection
The pool water to be measured must be connected to ASIN AQUA Net. Connect
the measured water inlet downstream of the pump, upstream of the fi lter and
ZPM (coagulation mixer).
Place the water valve fi tting to the T-joint, blinded by DN50 G1/4” threaded plug
#12134.
• The connecting fi tting is installed in G1/4” thread.
Aseko provides the unique Speedfi t connecting fi tting for measured water
connection to your ASIN AQUA Net. To connect the interconnecting tube, push
it into the Speedfi t connector and then lock it by pulling back. To disconnect the
interconnecting tube, push and hold a circular collet and pull the interconnecti-
ng tube out.
WARNING: To cut PE tube ends correctly, use a sharp knife (part of delivery).
The use of scissors or tongs deforms the tube end and leads to leaks.
WARNING:
Only hand tighten. Do not use tongs or any other tools.
1. To ensure tightness of joints, cut the tube at 90 ° angle.
•
Use the sharp knife to cut plastic. The cut must be clean and smooth.
2. Connect the water inlet to the measured water fi lter connection and the wa-
ter outlet to the probe housing connection. Make sure that measured water
pressure does not exceed 1.5 bar.
3.
The water outlet can be realized:
1. downstream of fi ltration
2.
to non-pressure (overfl ow tank)
3. upstream of fi lter pump
After the water inlet has been connected and opened, your ASIN AQUA Net is
ready to measure and adjust the pH and Cl value in your pool so as to achieve
the required values.
fi tting
G1/4” thread
CONNECTION
LOCKING
DISCONNECTION
Water valve fi tting
Inserting DN50
plug
G1/4” threaded
T-joint
90°
Pull out
6.2x4 hose
6.2x4 hose