Aseko ASIN AQUA NET CLF, Руководство пользователя

Страница: 20 / 36

EN 20
If you use the CLF probe
following conditions:
pH of the pool water
The ideal pH value should be between 6.8 and 7.5.
The pH of the pool water must be stabilized.
If the pH value fl uctuates, the value of the chlorine in pool water changes
accordingly.
Determination of the required chlorine value in pool
water
The required concentration of chlorine in pool water varies with the temperature
of the pool water. However, it should never be less than 0.3 mg/l. Determine the
required value using the table located on the left.
How to set the required chlorine value
Use a colorimeter or Pool Tester to measure the chlorine value in pool water
sample.
If the chlorine concentration (measured with a colorimeter or Pool Tes-
ter) is:
• ADEQUATE
to the value shown on the ASIN AQUA Net display
, your
device is ready to maintain the required concentration of chlorine in pool
water.
• BELOW
the required value shown on the ASIN AQUA Net display, in-
crease the required value over the current setting by 0.1 (by 0.2 mg/l max)
(regardless of the required value according to the table).
Repeat the measurement after the water in the pool is mixed thoroughly and the
required value shown on the ASIN AQUA Net display is settled. Repeat the pro-
cess until the
chlorine concentration in pool water matches the required
value
then set the correct required value according to the table. Subsequently
you can calibrate the CLF probe (see the chapter CLF Probe Calibration).
• HIGHER
than the required value shown on the ASIN AQUA Net
display - you can calibrate the CLF probe (see the chapter CLF Probe display display
Calibration).
NOTIFICATION:
Fix the low chlorine value in pool water by increasing required disinfection
value .
RECOMMENDATION:
Check the chlorine content in the pool once a week using the colorimeter or
tester.
Chlorine
Level mg/l
Water
Temperature
0,3 – 0,5 24 – 26 °C
0,5 – 0,8 26 – 32 °C
0,8 - 1 higher than 32 °C