X-3D-BL User’s Manual
king tube and some foam (e.g. foam from the X-3D-
FunPilot box). Shrinking the schrinking tube around
the pressure sensor pin and carefully add some super
glue to make it hold better. Attention: It’s very import-
ant that absolutly NO superglue get’s into the sensor!
Otherwise this very expensive part can take damage!
An alternative are sinter filter which you can get in
your modell store. The following pictures show both
variants:
4.3.2 Control modes X-3D FunPilot
The X-3D-FunPilot has three different control modes:
•
Heading Hold mode(HH)
•
X-ACC-mode
•
X-ACC + height control Modus
Switching between the modes can be done in two dif-
ferent ways:
•
3-step switch teached in to channel 5 (SW1 in
the X-Base configuration)
•
2-step switch teached in to channel 5 to switch
between X-ACC and HH mode. A second switch
teached in to channel 6 (SW2) for enabeling the
height control in X-ACC mode.
The recommanded default setting is the 3-step
switch. Use the second mode RC transmitters wi-
thout 3-step-switched. The mode can be changed
with the PC-Software seperately in every setting (in
datafusion/misc).
Attention: It’s very important to teach in the chan-
nels 5 and 6 in the X-Base receiver configuration!
Otherwise the UFO can get uncontrolable as it’s
switching modes undefenately.
4.3.3 Height control
The height controller is programmed as sink and
fall rate controller. Stick in the middle means: ”hold
height”. Starting from the ground is very easy. Just
push up the stick to full throttle until the UFO rea-
ched it’s desired height. Then put the stick back in the
middle. The UFO will try to hold it’s height as good
as it’s possible. This mode is more meant for outdoor
usage. The controller characteristics are calm and not
very agressive, so it’s possible and normal that the
UFO doesn’t climb to the desired height completlty
again afer a disturbance. Light and other air flows can
decrease the performance of the sensor. Using a air
filter is recommanded (see 4.3.1. It’s better to use a
spring on the throttle stick as well if you fly often
with the height control. Otherwise it can be hard to
find the middle of the stick. The deadzone can be in-
creased in the parameter settings if it’s necessary. The
thrust pulsing battery warnung should be switched off
www.x3d-shop.de
- 30 -
www.asctec.de
Содержание X-3D-BL
Страница 1: ...X 3D BL User s Manual V2 1 incl X 3D Mag...
