X-3D-BL User’s Manual
Choose the serial port and click on ”connect”. Se-
lect the ”X-3D Vx.x for X-Base.ufc” firmware file
after clicking on ”select firmware”. Then click on
”Upload”, wait for the upload to be completed, dis-
connect the USB adapter from the X-3D, remove the
bootloader jumper and click on ”Finished”. The X-3D
software update is now completed.
3.1.2 Software update of the
X-3D-FunPilot
Connect your X-USB module with your PC. After-
wards click on ”FP/OSP” in the X-Control software
and then on ”OSP Firmware Upgrade” on the left.
Now connect your X-3D-FunPilot with the X-USB
module.
Connect the battery to the UFO. To update the X-3D-
FunPilot software you need a jumper to activate the
boot loader mode of the X-3D-FunPilot. Bridge the
bootloader contacts and switch on the UFO.
Not click on ”Connect” in the PC software, then
on ”Choose firmware” and seleect the file ”X-3D-
FunPilot VX.X.hey”. Click on upload and wait until
the uploaded is finished. Disconnect the USB module,
remove the bootloader jumper and click on ”Ready”.
The software update is finished.
3.1.3 Software update of the X-Base
Again, you need a jumper to activate the so called
bootloader. Set the jumper as seen in the following
picture.
Open the X-Control software, click on ”X-Base” and
then on ”X-Base firmware Upgrade” on the left hand
side. Turn on the X-Base (In this case the battery has
to be connected to the UFO!) and connect the USB
adapter to the X-Base.
Choose the serial port (normally ”Autoselect:
COMxx”) and click on ”connect”. Select the ”X-
Base Vx.x for X-BL and ACT receiver.xbs” firmware
file if you are using an ACT receiver (35 or 40
www.x3d-shop.de
- 23 -
www.asctec.de
Содержание X-3D-BL
Страница 1: ...X 3D BL User s Manual V2 1 incl X 3D Mag...
