AS3424S Hardware Installation Guide
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 7 of 22
Similar to other electronic products, the semiconductor chip easily gets damaged if you power
on or off abruptly and frequently. To restart up the switch of ASCENT AS3424S, you have to
open the power on-off after the power is cut down for three to five seconds.
Avoid severe collision or falling down from the height to protect the parts in the switch.
Use correct outside ports to connect the switch of ASCENT AS3424S. Do not put the Ethernet
plug into the console port (RJ45 8-line socket). Similarly, do not put the console cable into the
console port (RJ45 8-line socket).
Note
1. When you plug or dial the power line, keep the power line horizontal with the power socket.
2. When the lifetime of our products ends, handle them according to national laws and
regulations, or send these products to our company for collective processing.
Keep dustless and clean during or after the installation.
Put the cover at the safe place.
Put tools at the right place where they are not easily falling down.
Put on relatively tight clothes, fasten the tie or scarf well and roll up the sleeve, avoiding
stumbling the machine box.
Put on the protective glasses if the environment may cause damage to your eyes.
Avoid incorrect operations that may cause damage to human or devices.
The safety notices mentioned here means that improper operation may lead to body damage.
Read the installation guide carefully before you operate the system.
Only professionals are allowed to install or replace the switch.
Pull out the AC power socket and close the direct-current power before operating on the
machine box or working beside the power source.
The final configuration of products must comply with relative national laws and regulations.
When you work under electricity, following the following principles:
