AS3424S Hardware Installation Guide
Solutions Provider for FTTx, RFoG, and HFC
www.ascentcomtec.com
Page 16 of 22
Figure 3-8 Connecting the 100GE QSF+ port and other Ethernet terminals
2.
Set the ports to 4 10GE ports
You can connect the QSFP+ optical module to the optical port and then you can connect other
Ethernet terminal devices with 10GE optical ports through the MPO-4*LC optical cable.
ASCENT AS3424S provides with 1 USB2.0 interface.
Before electrically starting up the switch, perform the following checkups after the switch is
installed:
If the switch is installed on the cabinet, check whether the installation point between the
cabinet and the switch is strong. If the switch is installed on the desk, check whether there is
enough space for the switch to discharge its heat and whether the desk is stable.
Check whether the connected power meets the power requirements of the switch.
Check whether the grounding line is correctly connected.
Check whether the switch is correctly connected to other terminal devices.
