ASBER ABBC-23-S/SG, Руководство по установке, использованию и обслуживанию

Страница: 13 / 20

ASBER – BAR EQUIPMENT: Operations and Service Manual/ Rev. JUN. 2015
PAGE 13
6 MAINTENANCE
STAINLESS STEEL CARE AND CLEANING
Proper cleaning of stainless steel requires soft cloths or plastic souring pads. Never use steel
pads, wire brushes or scrapers!
Cleaning solutions need to be alkaline or non-chloride cleaners. Any cleaner containing chlorides
will damage the protective film of the stainless steel. Chlorides are also commonly found in hard
water, salts, and household and industrial cleaners. If cleaner containing chlorides are used be
sure to rinse repeatedly and dry thoroughly upon completion.
Routine cleaning of stainless steel can be done with soap and water. Extreme stains or grease
should be cleaned with a non-abrasive cleaner and plastic scrub pad. There are also stainless
steel cleaners available which can restore and preserve the finish of the steels protective layer.
Never use and acid based cleaning solution! Many food products have an acidic content which
can deteriorate the finish. Be sure to clean the ALL food products from any stainless steel
surface. Common items include peppers, tomatoes and other vegetables.
6.1 CLEANING THE CONDENSER COIL
DANGER: Power must be turned off and disconnected from the power source
whenever performing maintenance, repair or cleaning the condensing unit.
Disconnect machine. Remove front bottom panel and carefully slide out the condensing unit.
The condenser coil requires regular cleaning; recommended every 30-60 days, depending of the
accumulation of dust and grease. If the buildup on the coil consists of only light dust and debris
the condenser coil can be cleaned with a simple brush. Heavier dust build up may require a
vacuum or even compressed air to blow though the condenser coil. If heavy grease is present
there are de-greasing agents available for refrigeration use and specifically for the condenser
coils. The condenser coil may require a spray with the de-greasing agent and then blown
through with compressed air.
Be sure all electrical and mechanical parts are dry before turning on the power.
Never use a high pressure water wash for this cleaning procedure as water can damage the
electrical components located near or at the condenser coil. Do not place filter material in
front of condenser coil. This material blocks air-flow to the coil similar to having a dirty coil!