Section I--Training Overview on the UF2000
Series Equipment
A. Welder
I .
Packaging and unpacking of UF2000/1
a)
The transport box is explained as push and vibration protection and offers
protection against transport influences.
b)
Transport the machine only in the special transport box.
c)
For loading and unloading of the machine, use the included lever belt.
d)
Do not force the machine into the box.
e) Pay attention to the correct seal of the box top!
2.
Securing the UF2000/1 for Transportation
To realize a maximum protection against damage and in the interest of a long
service, follow these steps:
a)
Stretch a short piece of pipe between the two middle clamping jaws
so that the right carriage cannot move. The carriage must be
unstressed.
⇒
Move the carriage close together to avoid a long projecting length of the
rack from the machine.
b)
Relieve back-run safety device, so that no pressure presses on the
compressing spring and thus the load cell in the internal of the machine.
c)
Put the included set collar over the projecting rack.
d)
Fix the set collar sturdy with the adjusting screw concisely to the machine frame.
e)
Secure the position lever of the plane and of the heating element against
slipping.
⇒
Tie the levers with the attached rubber band together and fasten it at the
hand wheel.
f)
If your machine is equipped with protective cover:
⇒
Pull the handle with the rubber band down and fasten it to
the machine using the handles for the heater and planer.
Important:
If done incorrectly, damages to the machine, particularly the load cell,
can
occur!
Pay attention that the rack is not exposed because this can lead to damages at the
load cell!
Asahi/America, Inc.
UF 2000/1
Page 3 of 1
8
