Aruba 9240, Руководство по установке

Страница: 18 / 29

18
| Installation
Aruba 9240 Gateway
| Installation Guide
Rack Mount Installation - Mid
This mounting option allows mounting the 9240 gateway from the middle in standard two-post 19-
inch Telco rack. The mounting brackets can be used for this installation as well.
Required Tools and Equipment
The following tools and equipment are required for installing a 9240 gateway:

Mounting Bracket (x2) (included in the kit)

Screws for mounting bracket (x8): M4 x 8 mm Phillips Flat Head Screws (included in the kit)

Screws for system rack mount (x4): M6 x 15 mm Phillips Pan Head Screws (included in the kit)

Suitable Screwdrivers for all screw types provided in the box (not included in the kit)
Installation Steps
To install a 9240 gateway from the middle in a standard two-point 19-inch Telco rack:
1. Place the mounting bracket over the mounting holes on either side of the gateway in the middle
(see Figure 7 ).
2. Secure the bracket to the gateway using the eight screws for the mount bracket (four per bracket)
and a suitable screwdriver.
Figure 7
Attaching the Rack Mounting Brackets-Mid
3. Mount the gateway within your organization’s rack system using the four screws for system rack
mount (two per bracket) and a suitable screwdriver (see Figure 8 ).
Leave a minimum of 10 cm (4 inches) of space on the left and right side of the gateway for proper air flow
and ventilation.
Leave additional space in the front and the back of the gateway to access network cables, LED status
indicators, and power cord.
Each 9240 gateway should have its own mounting equipment. Do not place other networking equipment
directly on top of a mounted 9240 gateway. Failure to do so can damage the device.
Some racks require screws that differ from those included with the 9240 gateway. Ensure that you have the
correct screws before installing the 9240 gateway.
1
2