PDU Jumper Cord (other countries) J8844A (8121-1094) HPE 2.5m C15 to C14 PDU Rest of World Power
Cord.
Installation procedures
Procedure
1. Prepare the installation site
on page 24.
Ensure the physical environment into which you will be installing the switch is properly prepared, including
having the correct network cabling ready to connect to the switch and having an appropriate location for the
switch. See
Installation precautions
on page 23 for some installation precautions.
2. Verify the switch passes self test
on page 24.
Plug the switch into a power source and observe that the LEDs on the switch’s front panel indicate correct
switch operation. When self test is complete, unplug the switch.
3. Mount the switch
on page 27.
The switch can be mounted in a 19-inch telco rack, in an equipment cabinet, or on a horizontal surface. The 8-
port switch (JL258A) can also be mounted on a wall or under a table.
4. Install or remove SFP/SFP+ transceivers
on page 34.
The switch has two or four slots for installing SFP/SFP+ transceivers. Depending on where you install the
switch, it may be easier to install the transceivers first. Transceivers can be hot swapped—they can be
installed or removed while the switch is powered on.
5. Connect the switch to a power source
on page 36.
Once the switch is mounted, plug it into the main power source.
6. (Optional) Connect a management console
on page 37.
You may want to modify the switch’s configuration, for example, to configure an IP address so it can be
managed using a Web browser, from an SNMP network management station, or through a Telnet session.
Configuration changes can be made by using the optionally ordered console cable to connect a PC to the
switch’s console port.
7. Connect the network cables
on page 40.
Using the appropriate network cables, connect the network devices to the switch ports.
At this point, your switch is fully installed. See the rest of this chapter if you need more detailed information on any
of these installation steps.
22
Aruba 2930F Switch Series Installation and Getting Started
Guide
