Art's Way LS1200R, Иллюстрированный перечень деталей, инструкции по установке и эксплуатации

Страница: 9 / 38

ix
system operates under extremely high
pressure and temporary repairs may fail
suddenly and create a hazardous situation.
• Wear proper hand and eye protection when
searching for a high-pressure hydraulic leak.
Use a piece of wood or cardboard as a
backstop instead of hands to identify and
isolate a leak. If injured by a concentrated
high-pressure stream of hydraulic fluid, seek
medical attention immediately. Serious
infection or toxic reaction can develop if
hydraulic fluid penetrates the surface of the
skin.
Transportation Safety
• Be sure to comply with all local regulations
regarding transporting equipment on public
roads and highways.
• Make sure the Slow Moving Vehicle (SMV)
emblem and all reflectors required by local
highway and transportation authorities are in
place, clean and clearly visible to all
oncoming or following traffic.
• Do not allow riders while transporting.
• Make sure the Grader is securely attached to
the tractor and install a safety chain to the
grader. Install a retainer through the drawbar
pin and attach the safety clip. Install cylinder
lock assembly to raise/lower hydraulic
cylinder and secure with clip.
• Do not fail to latch the tractor brake pedals
together.
• Do not exceed 20 MPH (32 km/h) when
transporting the grader. Always reduce speed
on rough roads and surfaces or when going
down inclines.
• Drive slowly when turning and always use
turn signals on the tractor to indicate your
turning intentions to other traffic.
• The weight of the trailed grader should
NEVER exceed the capacity of the towing
vehicle.
• Check clearances carefully whenever the
grader is towed.
Storage Safety
• Store the grader in an area away from human
activity.
• Do not permit children to play on or around
the stored machine.
• Park the Grader on firm level ground and
block the tires. Support the grader with the
jack provided and wooden blocks as needed.
Tire Safety
• Have a qualified tire dealer or repair service
perform tire repairs.
• Do not attempt to mount a tire unless you
have the proper equipment and experience to
do the job.
• Follow proper procedures when mounting a
tire on a rim to prevent an explosion which
could result in serious injury.
• Do not substitute tires of lesser road rating
and capacity for the original equipment tires.
CAUTION: Failure to follow proper
procedures when mounting a tire on a
wheel or rim can produce an
explosion, which may result in serious
injury or death. Do not attempt to mount a
tire unless you have the proper equipment and
experience to perform the job. Have it done
by your dealer or qualified tire repair service.
Assembly Safety
• Use adequate manpower to perform assembly
procedures safely.
• Assemble the grader in an area with sufficient
space to maneuver the largest components
and allow easy access to all sides of the
machine.
• Use only forklifts, lift cranes, jacks and tools
with sufficient capacity for the loads.
•
Do Not allow spectators in the working area.
Remember:
The Best Operator is a Safe Operator