Art's Way LS1200R, Иллюстрированный перечень деталей, инструкции по установке и эксплуатации

Страница: 36 / 38

MAINTENANCE
28
Wheel Bearings
Clean and repack wheel bearings once a year
or every 100 hours of operation with SAE
multi-purpose type wheel grease. To access
the wheel bearings:
1. Raise the wheel off the ground.
2. Remove hub cap and pull cotter pin from
the slotted nut.
3. Remove slotted nut, hub and bearing cones.
4. Clean all parts thoroughly and inspect for
damage or wear. Replace worn or
damaged parts as necessary.
5. Pack bearing and hub with SAE multi-
purpose type wheel grease.
6. Reinstall parts in the opposite order that
they were taken off. Tighten the slotted
nut only until a slight drag is felt on the
wheel bearings.
Figure 14. Hub and Wheel Bearing.
Service at the End of the Season
When work is completed for the season, clean
the implement thoroughly to remove dirt and
trash which would hold moisture and cause
rusting. Be especially observant of possible
moisture retention in the Sandbox.
Clean and repack the wheel bearings with
grease annually.
Paint all parts which have chipped or require
painting.
Inspect Grader for broken or missing parts.
See your dealer during the off season, so that
parts or service can be obtained when the
machine is not needed in the field.
Cap the hydraulic hose ends and store them in
the hose bracket on the side of the Grader
tongue. DO NOT let the hose ends lay on the
ground.
Store Grader under cover with all parts in good
operating condition.