Artistic studio Artristic Studio Easel, Руководство пользователя

Страница: 10 / 15

18 19
Attaching white boards and canvas
stretchers by their outer edges
Attaching white boards and canvas
stretchers by their outer edges
1
3
5
2
4
6
7
9
8
10
WARNING: DO NOT ATTACH VERY HEAVY, LARGE, CHIPBOARD, HARDWOOD
OR PLYWOOD BOARDS
� Unlock each of the eight T-Bar arm
clamps and extend each arm fully
� Double check that the board is sit -
ting flush up against all eight T-Bar
shelf end brackets and then start
screwing the 8, pointed rods into
the side edges of the canvas or white
board
� Reset the Hub into the upright
position again
� The pointed rods need only penetrate
the side of the canvas board by about
2mm
� Now you are ready to create your next
painting
� This what your Hub should look
like now
� Each of the four sides of the board should
be sitting on the shelves of the T-Bar arms,
and flush up against the end brackets
� Remove the 8 pointed rods, reverse
and re-screw them back into the T-Bar
arms but do not expose the points yet
� Now, on the underside of the canvas
or board, start re-locking all eight of
the T-Bar arm clamps
� Next, lay your canvas or white board
onto the top of the Hub, positioning the
centre of the board as close as you can over
the centre of the Hub, then start sliding
each T-Bar arm inwards towards the can -
vas/white board edges