Artistic Licence matisse Light-Switch II, Руководство пользователя

Страница: 11 / 44

Artistic Licence Engineering Ltd. matisse Light-Switch II & Switch-Edit user guide. 11/44
POWER
SUPPLY
Light-Switch is powered by an external 9 to 24VDC source. The power
connection is via Ferrules. A suitable power supply is PSU-9-1.5-FER.
The table below shows the wiring details.
The low voltage power lead can be extended up to 5m.
PIN FUNCTION
+VDC +9 to 24VDC @ 110 mA
GND GROUND
DMX512
CONNECTION
The DMX512 input (snapshot) /output is available at the 3-pin screw
terminal connector on the bottom left of the panel.
Pin 1 is marked in black on the rear panel diagram. Wiring is as follows:
PIN FUNCTION DMX Connector Colour
1 Screen Ground 1 Black / Screen
2 Data - 2 Blue
3 Data + 3 Red
PROGRAMMING
PORT
To programme Light-Switch, connect a
“USB A to B cable” to your
laptop.
WIRING
TOPOLOGY
Please refer to the Example Application section of this user guide for
wiring recommendations.
Terminology (used in DMX wiring):

Master: This is the actual DMX controller. There can only be one
master Light-Switch panel and it must be at the start of the
DMX cable.

Slave: There can be up to 30 slave Light-Switch panels on a DMX
line.
These terms are used when wiring a system using multiple Light-Switch
panels. They do not relate to the operation / zone settings of the
system.
WIRING
RULES

Only one Master on a DMX line, positioned at the start of the
DMX line

Maximum of 32 DMX fixtures (including Light-Switch Slave
panels). You can increase this number by using a RDM splitter
such as versaSplit, rackSplit octo or Rail-Split RDM

Maximum of 30 Slave panels

Light-Switch wiring is independent of the zones being used.

The DMX line must be terminated as specified by the DMX512
protocol

If splitters are to be used, they must be RDM compatible