The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass pan‐
el frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal glass
panel in the seats correctly.
A
How to replace: Lamp
WARNING! Risk of electric
shock.
The lamp can be hot.
Always hold the halogen lamp with a cloth
to prevent grease residue from burning on
the lamp.
Before you replace the lamp:
Step 1
Step 2
Step 3
Turn off the oven. Wait until
the oven is cold.
Disconnect the oven from
the mains.
Put a cloth on the bottom of
the cavity.
Back lamp
Step 1
Turn the glass cover to remove it.
Step 2
Clean the glass cover.
Step 3
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4
Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
In any cases not included in this table
please contact with an Authorised Service
Centre.
Problem
Check if...
The oven does not
heat up.
The fuse is blown.
Problem
Check if...
The door gasket is
damaged.
Do not use the
oven. Contact an
Authorised Service
Centre.
The display shows
"12.00".
There was a power
cut. Set the time of
day.
31
Содержание AODEC70X
