ARTEX/ACR Electronics, Inc.
A3-06-2824 Handheld Programmer Operations Manual
Y1-03-0272 Rev. F
Company Confidential
Page 24
•
In the top right corner, select
“Options”
once. It will change to
“Get Options”
.
•
Select “Get Options”; quickly place ELT switch in test mode and release.
(*Quickly is <1
second)
•
If successful, the programmer will read the currently programmed baud rate and
show
“GPS Baud
4800
”
or
“GPS Baud
9600
”
. If the baud rate is correct, select
return. If not, change the baud rate. Momentarily hold ELT in test mode; quickly
tap on
“Set”
, and release. Programmer should state
“Successfully programmed
speed”
. Select
“Return”
.
•
If failed, programmer will state
“Failed to read
GPS
speed”
. If failed, select
“Return”
and start NOTE 1 over.
NOTE 2: For the ELT 3000 and ELT 4000, there are options that must be set
manually.
•
In the top right corner, select
“Options”
once. It will change to
“Get Options”.
•
For the ELT 3000,
“
121.5 MHz
”
and
“
243 MHz
”
will be selected.
•
For the ELT 4000, only “121.5 MHz” will be selected.
•
Select either
“Serial”
,
“A429 High” or “A429 Low”
.
•
Set
“Prog. Adapter”
to
“Enabled”
if using programming adapter A3-06-2868.
“Disabled”
is not using a programming adapter.
•
Set
“ARINC Speed”
to
“High”
or
“Low”
depending on the speed the GPS will be
communicating with the ELT 3000 or ELT 4000.
•
After the above items are selected, tap on
“Set”
. The programmer will state
“Successfully programmed options”
. If failed, the programmer will state
“Failed to
program
options”
.
