Artesyn Embedded Technology ATCA-7365-CE, Инструкция по установке и эксплуатации

Страница: 178 / 288

Maps and Registers
ATCA-7365-CE Installation and Use (6806800L73N )
178
6.3.4.2.9 Modem Status Register (MSR)
This 8-bit register provides the current state of the control lines from the modem or data set
(or a peripheral device emulating a modem) to the processor. In addition to this current state
information, four bits of the Modem Status Register provide change information. Bits 03:00 are
set to a logic 1 when a control input from the Modem changes state. They are reset to a logic 0
when the processor reads the Modem Status Register.
5 Transmit Holding Register Empty (THRE) indicator
THRE is set when the THR is empty, indicating that the ACE is ready to
accept a new character. If the THRE interrupt is enabled when THRE is set,
an interrupt is generated. THRE is set when the contents of the THR are
transferred to the TSR. THRE is cleared concurrent with the loading of the
THR by the CPU. In the FIFO mode, THRE is set when the transmit FIFO is
empty; it is cleared when at least one byte is written to the transmit FIFO:
1: THR/Transmit FIFO empty
0: THR/Transmit FIFO contains data 0 LPC: r
6 Transmitter Empty (TEMT) indicator
TEMT bit is set when the THR and the TSR are both empty. When either the
THR or the TSR contains a data character, TEMT is cleared. In the FIFO mode,
TEMT is set when the transmitter FIFO and shift register are both empty:
1: THR/Transmit FIFO/TSR empty
0: THR/Transmit FIFO/TSR contains data 0 LPC: r
7 FIFO data error
In the FIFO mode, LSR7 is set when there is at least one parity, framing, or
break error in the FIFO. It is cleared when the microprocessor reads the LSR
and there are no subsequent errors in the FIFO. If FIFO is not used, bit always
reads 0:
1: FIFO data error encountered
0: No FIFO error encountered 0 LPC: r
Table 6-35 Line Control Register (LCR) (continued)
LPC IO Address: Base + 5
Bit Description Default Access