Artecta Carlow 30, Руководство пользователя

Страница: 12 / 24

11
Ordercode: A0720060
Carlow 30
Control Panel
A) LED display
B) Mode button
C) Setup button
D) Up button
E) Down button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the back side of the device allows you to assign DMX fixture addresses, which is the
first channel with which the Carlow will respond to the controller.
Please note, when you use the controller, the unit has 9 channels.
When using multiple Carlows, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Carlow should be 1(001); the DMX address of the second Carlow
should be 1+9=10 (010); the DMX address of the third Carlow should be 10+9=19 (019), etc. Please, be
sure that you do not have any overlapping channels in order to control each Carlow correctly. If two or
more Carlows are addressed similarly, they will work similarly.
Controlling:
After having addressed all Carlow fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Carlow will automatically detect whether DMX 512 data is received or not.
If not, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Carlow.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 10 seconds
When no button is pressed for 10 seconds, the display will turn off. The fixture will switch to a lock key
mode. To light up the display and unlock the fixture, you have to press the Mode and Down button at the
same time for 2 seconds. Once you have pressed the buttons, the display will light up.