Artecta Carlow 30, Руководство пользователя

Страница: 9 / 24

8
Ordercode: A0720060
Carlow 30
Installation
Remove all packing materials from the Carlow 30. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 5 modes: • Auto run
• Built-in programs
• Static Color
• Master/slave
• DMX-512 (5CH, 7CH or 9CH)
One Carlow 30 (Auto Run Mode, Built-in programs and Static Color Mode)
01)
Fasten the effect light to a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Carlow 30 is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 13 and 14 for more information about Auto Run Mode, the Built-in programs and
Static Color Mode.
Multiple Carlows 30 (Master/Slave control)
01) Fasten the effect light onto a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-p XLR cable to connect the Carlows and other devices.
The pins: 1. Earth
2. Signal (-)
3. Signal (+)
03) Link the units as shown in Fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using the 42707 – DMX Extension cable. Link the second, third, and fourth units using the
42707 – DMX Extension cable.
You can use the same functions on the master device as described on pages 13 and 14 (Auto Run
mode, Built-in programs, Static color). This means that you can set your desired operation mode on
the master device and all slave devices will react the same as the master device.
Multiple Carlows 30 ( Master/Slave control)
Fig. 03