Make sure the model’s CoG is within the range
shown here. In the ideal situaion, the CoG is
between 60~70mm from the leading edge of
the wing.
PRE-FLIGHT INSPECTION AND ADJUSTMENT
1. Install 8 ‘AA’ cells into the transmitter according to the battery’s polarity, then turn on the transmitter.
Install the full charged flight battery into the battery compartment of the fuselage and connect the battery
to the electronic speed controller (ESC).
2. The right stick of transmitter controls the aileron when pushed left or right: when you push the stick
to the left, the left aileron of plane will lift and the right aileron of plane will drop in response and vice versa
for when the aileron is pushed right.
Before flying, put the trim of aileron to the middle position and then adjust both the ailerons to the neutral
position with the control rod.
3 .The left stick on the transmitter controls the power of motor when pushed backwards for forwards
When holding the fuselage of the plane, please keep objects away from the propeller to avoid hurting
people or damaging the propeller. If you pull the left stick to the lowest position, the motor will stop.
Now the motor is on standby. You can check the motor by pushing the stick up slowly.
4. The up and down movement of the right stick of transmitter controls the movement of the elevator.
When you pull the stick back, the elevator of plane will lift and vice versa when you push the stick forward.
The best state before flying is the elevator sticks and trim are all in the neutral position.
5. The left stick on transmitter controls the rudder when you push the stick to the right, the rudder of
plane will turn right and vice versa when the stick is pushed left. The rudder stick and trim should be neutral
before flying.
6. If the servos and motor give no response during setup, please check all connections and make sure the
battery is fully charged and the transmitter and receiver are bound together.
7. Check the CoG of the model. The proper CoG position should be 60~70 mm away from the leading edge,
please refer to the picture. If in any doubt contact your dealer.
Note: The transmitter and receiver must be the same 2.4GHz protocol. Unmatched sets will not be
compatible and may cause loss of control.
