Art-Tech ALPHA JET, Инструкция по эксплуатации

Страница: 10 / 12

9
Make sure to check the CG of the model, the CG of ALPHA JET should be between the ranges in below picture.
The proper CG position should be 450~470mm away from the front.
4
5
0
~
4
7
0
m
m
Center of Gravity Check
The possible problems and solutions
Phenomenons Problems Solutions
Motor does not run
1. Battery is not fully charged.
2. The battery in the transmitter
is not full.
3. The circuit in “ALPHA JET” has
been damaged due to Crash
1. Charge the battery.
2. Install new dry cells.
3. Maintain or contact the local
distributor for help.
Can not fly straight
Elevator and / or Ailerons are
out of trim
Adjust the trim switch of the
appropriate control to correct.
Can not climb
Limited control range
1.The battery is not fully
charged.
2.Both elevators leaning downward
1. Charger the battery
2. Adjust the micro-trim switch
on the transmitter to make the
two elevators upward
1. The batteries are almost flat
2. The transmitter was fault
1. Install new batteries
2. Contact the local distributor
for help.
WWW.ART-TECH.COM
www.motionrc.com