Arroyo Instruments TECPak 586 Series, Руководство пользователя

Страница: 33 / 40

586 TECPak User’s Manual · Page 33
Error Messages
Error
Code
Description Cause
E-100 General Error The error code is non-specific, and is
generally used when no other error code
is suitable.
E-102 Message too long The message is too long to process
(USB/Serial only).
E-104 Type not allowed The RADix type was invalid
E-123 Path not found The message used an invalid path
command (USB/Serial only).
E-124 Data mismatch The message contained data that did not
match the expected format (USB/Serial
only).
E-126 Too few or too many
elements
The command requires more or less than
the number of parameters actually
supplied.
E-127 Change not allowed An attempt was made to change a
parameter that cannot be changed, or is
currently read-only.
E-201 Data out of range The message attempted to set a value
that was outside the allowable range
(USB/Serial only).
E-202 Invalid data type When trying to parse the message, the
data was in an invalid format (USB/Serial
only).
E-204 Suffix not valid An invalid number base suffix (radix) was
encountered when parsing a number
(USB/Serial only).
E-217 Configuration Recall
Failed
Recall failed, typically due to attempted
recall on an empty bin.
E-218 Configuration Save
Failed
Save failed, either due to an out-of-range
bin, or write error to the EEPROM.
E-402 Sensor open, output
turned off
A sensor open circuit was detected and
the output was turned off.
E-403 Module open, output
turned off
A Peltier module open circuit was
detected and the output was turned off.
E-404 I limit, output turned
off A current limit was detected and the
output was turned off.
E-405 V limit, output turned
off A voltage limit was detected and the
output was turned off.
E-406 Sensor limit, output
turned off
The sensor limit (high or low) was
exceeded and the output was turned off.