Arroyo Instruments TECPak 586 Series, Руководство пользователя

Страница: 34 / 40

Page 34 · 586 TECPak User’s Manual
Error
Code Description Cause
E-407 Temperature limit,
output turned off
The temperature limit (high or low) was
exceeded and the output was turned off.
E-409 Sensor changed,
output turned off
The sensor type was changed, causing
the output to be turned off.
E-410 Temperature was out
of tolerance, output
turned off The temperature went out of tolerance
and the output was turned off.
E-415 Sensor short, output
turned off
A sensor short circuit was detected and
the output was turned off.
E-416 Cal failed An error occurred during calibration that
caused the calibration to fail. The unit is
no longer in calibration mode.
E-419 TEC not stable The TEC is considered stable if the
temperature has changed less than
0.02°C for more than 20 seconds.
E-433 Not a TEC The TEC:CHAN command attempted to
select a non-TEC channel
E-435 Mode Change A mode change occurred when the
output was on, forcing the output off.
E-436 Auto Tune Failed AutoTune was cancelled for whatever
reason.
E-437 Auto Tune Required
T Mode AutoTune can only start in T mode.
E-439 Thermal Runaway System detected a thermal runaway and
shutdown the output.
E-997 Control error, cycle
power A hardware control error occurred, cycle
power to resolve. If error continues to
occur, contact factory.
E-998 Command not
supported
A command was received that is not
supported by this instrument.
E-999 Non-specific error A non-specific error was encountered.