Arrma ADX-10, Руководство пользователя

Страница: 10 / 40

© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
DESIGNED FAST. DESIGNED TOUGH.
10
Hex Drivers
Not Supplied
Allen Keys
Supplied
Cross wrench
Long Nose Pliers
1.3mm (0.050")
1.5mm
5.5mm
7mm
4mm
2mm
2.5mm
Nut Drivers
Turnbuckle Wrench
Cloth
Automotive
Brake
Cleaner or
Nitro Car
Cleaner
HAZARDOUS/FLAMMABLE:
Adult supervision required, use
only in a well ventilated area and
away from sources of ignition.
Brush
Oil
Spray
Grease
Tyre Glue
Thread-lock
Recommended Tools
1.3 (0.050"), 1.5, 2, 2.5mm
Maintenance
Basic Trouble Shooting
- need help? Visit the support area and forums at ARRMA-RC.COM
Trouble Shooting Matrix
Problem Possible Cause Solution
VEHICLE DOES NOT MOVE
Batteries are incorrectly installed in
transmitter Check transmitter batteries and refit.
Weak, damaged or no drive battery in
model Install fresh, charged battery
Frayed or broken motor or electronic
speed control (ESC) wires Check condition, reconnect and insulate. Visit
the GO FOR IT! forum for advice
Electronic speed control (ESC) has shut
down due to overheating Stop driving and allow electronic speed control
(ESC) or motor to cool down
Electric motor is damaged Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
El e c t r o n i c s p e e d c o n t r o l ( E S C ) i s
damaged Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
Possible damage to transmission/drive-
line Check components and replace - visit ARRMA-
RC.com for advice
El e c t r o n i c s p e e d c o n t r o l ( ES C ) l o w
voltage cutoff has activated. Remove drive battery, leave to cool down if
necessary, and re-charge
V E H I C L E D O E S N O T
REVERSE
Electronic speed control (ESC) reverse
mode switched off Adjust reverse on electronic speed control
(ESC)
El e c t r o n i c s p e e d c o n t r o l ( E S C ) i s
damaged Replace with new unit - visit ARRMA-RC.com
for advice and upgrades!
VEHICLE DRIVES WITHOUT
INPUT
Transmitter throttle trim incorrectly set Throttle trim needs to be set to zero/neutral.
Neutral throttle position of Electronic
Speed Control (ESC) incorrect. Set throttle trim to zero and switch electronic
speed control (ESC) off and then on again, a
chime to indicate the new neutral position has
been set
SHORT RUNTIME
Battery damaged or not fully charged Check condition, replace or recharge
Electric motor dirty or damaged Clean, check condition and/or replace - visit
ARRMA-RC.com for more information
Incorrect electronic speed control (ESC)
battery mode. Adjust the battery mode of the electronic
speed control (ESC)
SLUGGISH PERFORMANCE
Battery damaged or not fully charged Check condition, replace or recharge
Transmitter throttle trim incorrectly set Throttle trim needs to be set to zero/neutral.