Armedica AM-700 Series, Руководство пользователя

Страница: 6 / 12

PLATFORM MOUNT MANUAL PARALLEL BARS INSTALLATION
AM-707, AM-710
1. Remove platform (49) from crate.
DO NOT LIFT OR SUPPORT BY END RAMPS!!
2. Set the platform on supports to get it off the floor far enough to allow access to the
carriage bolts (45) during installation of the four upright supports.
3. Remove the retaining nuts and cap retainer washers from mounting bolts.
(Non locking nuts used for shipping only)
4. Locate the four upright supports (42) and place on the platform (46) according to letter
designations, with the height adjustment knobs facing outward as shown on page 8. Hold
carriage bolts in place from the bottom of platform, if necessary, to install upright supports,
cap retainer washer (47), and lock nut (7). NOTE: The square portion of the carriage bolts
must be properly seated on the bottom of the platform to reach completely through the
platform, support plate, washer and lock nut.
5. Tighten all lock nuts securely and install plastic bolt covers (48).
CAUTION: Do not over tighten or carriage bolts may pull too far through platform.
6. Place the handrails into position in the adjustment tubes and tighten the setscrews (38).
FLOOR MOUNTED PARALLEL BARS INSTALLATION
AM-711, AM-712
NOTICE: Armedica does not supply floor mounting hardware
. A qualified professional
should install the Floor Mounted Parallel Bars using hardware appropriate for the flooring material.
Reference the floor layout drawing on page 9 to position the parallel bar support assemblies on
the floor.
MANUAL PARALLEL BARS OPERATING INSTRUCTIONS
AM-707, AM-710, AM-711, AM-712
ADJUSTING THE WIDTH AND HEIGHT OF THE PARALLEL BARS
 Turn knobs to release adjusting tubes and set to the desired width.
 Make sure adjusting tube knobs are securely tightened before use.
PRECAUTIONS
CAUTION: When lowering or raising the parallel bars, keep hands and feet away from the moving parts.
CAUTION: Do not adjust the width or height of the parallel bars with the patients weight on the parallel
bars.
CAUTION: Make certain the parallel bar height and width adjusting mechanisms are secure before use.
The motor is double insulated for protection from EMI. This equipment has been tested and found to comply
with the limits for medical devices to the IEC 60601-1-2: Third edition 2007-03. These limits are designed to
provide reasonable protection against harmful interference in a typical medical installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to other devices in the vicinity. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to other devices, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving device.
- Increase the separation between the equipment.
- Connect the equipment into an outlet on a circuit different from that to which the
other device(s) are connected.
- Consult the manufacturer or field service technician for assistance.
5